144 Radiographic Assessment of the Patient With a Total Hip Replacement 
An error of level Warning was generated in file
/www/ems/mpacms/templates/include/dc_new/top.inc on line 296.  The error
message was:
main(https://www2.dynamicchiropractic.com/include/dc_new/analyticstracking.php)
[function.main]: failed to open stream:
Interrupted system call
An error of level Warning was generated in file
/www/ems/mpacms/templates/include/dc_new/top.inc on line 296.  The error
message was:
main() [function.include]: Failed opening
'https://www2.dynamicchiropractic.com/include/dc_new/analyticstracking.php'
for inclusion (include_path='.')
The directory 'https://www2.dynamicchiropractic.com/include/dc_new' does not exist.
You may need to type the following:
$ cd .
$ cvs up -d



	

		
		

			




			

			

				
				
				
			

			
		
		

	


	





		


















Printer Friendly
Email a Friend
PDF
RSS Feed




























	

		
			Dynamic Chiropractic – July 29, 2011, Vol. 29, Issue 16		
		

		
	











Radiographic Assessment of the Patient With a Total Hip Replacement



By Deborah Pate, DC, DACBR








Osteoarthritis of the hip affects more than 4 million people in the U.S., and over 200,000 primary elective total hip replacements (THR) are performed per year.
			

		 The number of revisions due to failure or just wearing out is estimated at 37,000, but there is no national total joint registry in the U.S. Therefore, there are no reliable estimates of the annual and cumulative rates and determinants of THR failure in the smaller hospitals that perform the vast majority of THR. (The lack of data on U.S. procedure volume and outcomes is not the topic for this article; it is just interesting to note that we rely on data from large referral-based hospitals and the national total joint registries developed in Scandinavian countries to monitor failure of THR for determining outcomes.) 






  


    
Indications for THR Revision According

to the Swedish Hip Arthroplasty Register		
  

  


    
Reason for Revision
    
Rate of Occurrence
  

  


    
Aseptic Loosening
    
75%
  

  


    
Deep Joint Infection
    
8%
  

  


    
Dislocation
    
6%
  

  


    
Fracture
    
5%
  

  


    
Technical Error
    
3%
  

  


    
Implant Fracture
    
1%
  

  


    
Other
    
4%
  



Failure of the prosthesis is costly and disabling. Because THR are increasing, it is very likely that you have patients with THR and need to be aware of some of the complications. Consider the data from the Swedish Hip Arthroplasty Register. (See Table) As you can see, the prostheses can become infected, either by direct inoculation of the joint at the time of the initial surgery or by joint seeding during bacteremic episodes over longer-term follow-up. Fractureof a prosthetic component occurs rarely following primary THR. Incorrect alignment of the components and poor compliance with postural restrictions can lead to repeated dislocations. Suboptimal component design or positioning can lead to mechanical loosening. Repeated wear of the polyethylene or other materials can generate wear debris that incites osteolysis, with resorption of bone. Osteolysis is not distinguished from aseptic loosening in the Swedish Hip Register data.




	
Angle of inclination - Copyright – Stock Photo / Register Mark


	Figure 1: Angle of inclination 40o  +/- 10°.

Of course, as chiropractors we are not able to do anything about these complications, but we should evaluate any patient with a THR who has symptoms that might indicate problems with the THR. A simple AP pelvis view can be very helpful in determining if there are problems with the THR. If the patient has their initial baseline X-rays, a quick comparison can be employed to evaluate even slight changes in the prosthesis. Alignment and positioning should mimic normal anatomy. 




	
Center of rotation - Copyright – Stock Photo / Register Mark


	Figure 2: Center of rotation should be equal for both hips.


The position of the acetabular component and the stem can be easily assessed on an AP view. The acetabular angle of inclination should be 40 degrees +/- 10 degrees. (Figure 1) Anteversion cannot be assessed on the AP and a frog leg view is very difficult to obtain in these patients, so CT is often used to assess this angle. The center of rotation, however, can be assessed on the AP view. (Figure 2) 




	
Leg-length discrepancy - Copyright – Stock Photo / Register Mark


	Figure 3: Leg-length discrepancy measured by comparing the lesser trochanter position (they should be parallel).

The distance from center of the femoral head to teardrop (or other identifiable landmark) should be equal bilaterally. The iliopsoas tendon should pass just lateral to the center of the femoral head and helps to keep the hip in proper alignment. Excessive lateral positioning of the acetabular component results in the iliopsoas tendon crossing medial to the femoral head, placing the patient at risk for dislocation. 




	
stem of the femoral component - Copyright – Stock Photo / Register Mark


	Figure 4: Loosening of the stem of the femoral component of the THR.


The center of the rotation will be different when comparing the hips. Leg-length discrepancy can also be a factor in THR complications. (Figure 3) This can also be assessed on the AP projection. The only other view one needs to take is an AP view of the THR side (which includes the femoral stem) to rule out loosening of the stem. (Figure 4)



These are just basis assessments of a THR, but will help in determining if the patient's symptoms are attributable to a problem with the THR. Most patients do well with total hip replacements, but when problems develop, chiropractors may be the first to see the patient. These simple assessments will help determine if the patient needs further follow-up and revision.


Click here for more information about Deborah Pate, DC, DACBR.




















		






			

			


			







To report inappropriate ads, click here.